Battery Removal/Installation - Hitachi Koki CL 10D2 Instrucciones De Manejo

English
3. Trimmer
Screw size
M10 × 1.5
M8 × 1.25
M6 × 1
W3/8" × 1.5875
Optional accessories are subject to change without notice.
APPLICATIONS
Cutting of soft steel studs.

BATTERY REMOVAL/INSTALLATION

1. Battery removal
Firmly support the power tool and remove the
battery while pushing the latch of the battery with
your thumb (Fig. 1).
CAUTION:
Never short-circuit the battery.
Support the battery with your palm so that it does
not fall down.
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 1).
Trigger
switch
Push
Latch
5
Handle
Insert
Pull out
Rechargeable battery
Fig. 1
CHARGING
Before using the power tool, charge the battery as follows.
1. Connect the charger's power cord to a receptacle.
When the power cord is connected, the charger's
pilot lamp will blink in red. (At 1-second intervals).
2. Insert the battery into the charger.
Position the battery so that the nameplate faces
toward the caution plate of the charger and push
in the battery until it contacts the bottom plate. (See
Figs. 2 and 3.)
CAUTION:
If the batteries are inserted in the reverse direction,
not only recharging will become impossible, but it
may also cause the fuse to blow, or problems in
the charger such as a deformed recharging terminal.
3. Charging
When inserting a battery in the charger, charging
will commence and the pilot lamp will light
continuously in red.
When the battery becomes fully recharged, the pilot
lamp will blink in red. (At 1-second intervals.) (See
Table 1)
(1) Pilot lamp indication
The indications of the pilot lamp will be as shown
in Table 1, according to the condition of the charger
or the rechargeable battery.
Rechargeable
battery
Rechargeable
battery
Insert
Latch
Nameplate
Fig. 2
Hole for connecting
the rechargeable
battery
Pilot lamp
Fig. 3