Technical Data - brennenstuhl Premium City SH 2705 PIR IP 44 Manual De Instrucciones

Operating Instructions
D

TECHNICAL DATA

Nominal voltage:
Nominal power:
Protection type:
Protection class:
The LED lamp is solely for normal use and not designed for raw operation.
Motion detector range:
Duration:
Ambient temperature:
INSTALLATION
Notice: The lamp must be installed on a dry, stable and solid surface in accordance with the
speciications in Fig. B. Ideally, the LED lamp should be installed 1.8 to 2.5 above the ground (see
Fig. B).
Install the lamp (see Fig A)
Release the screw
plate . Use the assembly plate to mark the positions of the screw holes on the assembly surface.
4
Important: Make sure not to drill into any hidden lines. Guide the power cable through the cable
bushing on the assembly plate and attach it to the wall using the screws
6
Attach the power cable to the lustre terminal
= green / yellow cable, L = brown cable).
Reattach the body of the lamp to the assembly plate. To do this, press the unlock button
slide the lamp onto the assembly plate until the unlock button
connection by screwing it to the terminal box
Set the desired direction of the light and tighten the screws. Switch the main power supply on.
Only for model SH 2705 PIR IP 44 and LH 2705 PIR IP 44
The motion detector should not be directed at heat sources such as grills, air conditioners, other
outside lighting, moving cars and exhaust shafts in order to avoid annoying false triggering. For
the same reason, the motion detector should not be installed in areas with strong electromagnetic
interference. Do not direct the device at relective surfaces such as smooth white walls, swimming
pools, etc.
The technical speciications for the sensor range (max. 10 meter at 180 °) can vary slightly
depending on the installation height and location. The sensor range on the device can also
change if the temperature changes. Before you select the installation location for the device, you
should know that the motion detector reacts most sensitively to movements that run straight
across its range and least sensitively to movements that run directly toward or away from the
motion detector (see Fig. C). If the movement is directly toward or away from it, this means a
signiicant reduction of the sensor range (see Fig. C).
8
BA_City_LED_Horizontal_A5_130723.indd 8
220–240 V~ 50 / 60 Hz
27 x 0,5 W LED
IP 44
I
180 ° and max. 10 meter, adjustable
adjustable from 10 (+/– 5) seconds up to 4 (+/– 1) minutes
–15 °C – + 45 °C
on the terminal box, press the unlock button
1
Premium LED spotlight /zone lighting
3
in accordance with Fig. A (N = blue cable,
2
locks back into place. Secure the
3
.
1
and remove the assembly
and dowels
5
and
3
23.07.13 16:53
.
7