After Use; Cleaning And Care - Silvercrest SDM 1500 C2 Instrucciones De Uso

10) When you are fi nished treating all of the surfaces, press the "Steam"
button r to stop steam production.
11) Set the on/off switch u to "O". The POWER control lamp 0 goes out.
12) Remove the power plug from the mains power socket.
NOTE
► If you see streaks on the fl oor after cleaning with the appliance, this may
be due to the previously used cleaning fl uids. Simply clean the fl oor again
using the steam mop. The smears should now be gone.

After use

1) Allow the appliance to cool down.
2) Remove the pad 6.
3) Remove the water tank 8 from the appliance and empty it.
4) Pull the upper cable hook z out a little and turn it back upwards.
Wind the cable back around the two cable hooks z/i.
Fix the end of the power cable using the cable clip located on the cable.

Cleaning and care

RISK OF ELECTRIC SHOCK!
► Always remove the mains power plug before cleaning the appliance!
WARNING – RISK OF INJURY!
► Allow the appliance to cool down before cleaning it. Risk of burns!
CAUTION – PROPERTY DAMAGE
► When cleaning the surfaces use neither abrasive or chemical cleaners,
nor sharp or scratchy objects.
Empty the water tank 8 after every use.
■
After each use, remove the pad 6 from the steam foot 5 and wash it out.
■
SDM 1500 C2
GB │ IE │
29 ■