Assembly; Initial Operation - Silvercrest SOR 2600 C1 Serie Instrucciones De Uso

Assembly

Use the fold-out page of these instructions to assist
you with assembly.
1) Remove the oil radiator and all components from
the box and remove all packaging materials.
2) Place the oil radiator, with the base uppermost,
on a soft surface, for example a carpet.
3) Place a mounting bracket
element so that the threaded parts project
upwards.
4) Lay a roller rail
threads protrude through the holes. Check to
ensure that the recesses on the roller rails
are facing outwards. The screw ends project-
ing from the appliance must reach into the
recesses.
5) Screw one wing nut
the threaded ends of the mounting bracket
6) Proceed in the same manner with the other side.
7) Turn the appliance over and place it on the rollers.

Initial operation

1) Unwind all of the power cable from the power
cable retainer .
NOTE
► Ensure that the thermostat
level switch are standing at MIN resp. 0.
2) Insert the plug into a mains power socket.
3) Set the heat level switch
thermostat to MAX. The "Power" control
lamp illuminates.
■ 14 │ GB │ IE
under the heater
over it, such that the screw
hand tight onto each of
and the heat
to "3" and the
NOTE
► You can use the heat level switch
late how quickly the appliance warms up.
If you wish to heat it up particularly quickly,
select heat level "3", if a slow warming up is
preferred, select heat level "1".
Using the thermostat
desired temperature.
4) When the desired room temperature has been
reached, slowly turn the thermostat
down until a quiet "click" is heard and the
"Power" control lamp
room temperature will now be retained. The
"Power" control lamp
ally then switch back off after a short while.
This merely means that the programmed room
temperature has fallen below this level for a
short period and the appliance has warmed
.
itself back up.
NOTE
► If you want to heat a room up particularly
quickly, you can also activate the heating fan
switch . When the fan heater is switched
ON, the heating fan control lamp
nates and hot air is blown through the hot air
outlet into the room.
5) If you wish to switch the appliance off, first set the
heating fan switch
fan control lamp
heat level switch to
thermostat
6) Remove the plug from the mains power socket.
you can set it to the
goes out. The current
will light up occasion-
to OFF so that the heating
goes out. Next, turn the
to "0" and then the
to MIN.
SOR 2600 C1
to regu-
back
illumi-