Cutting Hair; Cutting A Hairline; Trimming A Beard - Silvercrest SHBS 600 A1 Instrucciones De Servicio

BB*5$B%ERRN 6HLWH  'LHQVWDJ  1RYHPEHU    

6.3 Cutting hair

NOTES:
• The hair to be dressed must be dry.
• The cutting length may deviate depend-
ing on the cutting angle.
• Place a hairdressing cape|15 around
throat and neck to prevent cut-off hair from
dropping into the collar.
• Comb the hair well.
• First, start with a comb attachment|1
with a longer cutting length and then, in
the course of the cutting process, use
shorter cutting lengths step by step.
• Start by cutting the hair in the neck or
on the sides and cut towards the centre
of the head. Then, cut the front section
of the hair towards the centre of the
head.
• Hold the hair and beard trimmer|4 in
such a way that the comb attachment|1
lies as flat as possible on the head.
Move the device evenly through the hair.
• If possible, cut against direction of hair
growth.
• In order to catch all the hair, move the
hair and beard trimmer|4 several times
through each section of the hair.
• Comb the hair repeatedly and well.
• In order to achieve a straight cutting line
for cutting lengths over 12 mm, the hair
and beard trimmer|4 should be passed
through the hair several times from dif-
ferent directions.
• By shifting the switch for cutting length
fine tuning|5 the cutting lengths can be
set in steps of 0.5 mm.
Example Comb attachment 16–
18 mm:
Top position (0.5 mm): shorter hair
(16 mm)
Central position (1.5 mm): 17 mm
Bottom position (2.5 mm): longer hair
(18 mm)
44 GB
Comb Cutting length fine
attach- tuning|5 (mm)
ments|1
0.5 1.0 1.5
(mm)
4–6 4 4.5
7–9 7 7.5
10–12 10 10.5 11 11.5
16–18 16 16.5 17 17.5
22–24 22 22.5 23 23.5
28–30 28 28.5 29 29.5

6.4 Cutting a hairline

• Put the edge of the trimmer attach-
ment|3 at the desired hairline height
and move the hair and beard trimmer|4
downwards.

6.5 Trimming a beard

NOTE: please keep in mind that the corre-
sponding cutting lengths are only achieved,
if the hair and beard trimmer|4 is held at a
right angle to the skin surface.
• Comb the beard in the direction that it
grows.
• Trim the beard downwards from ear to
chin. First trim one side, then the other.
• Use the trimmer attachment|3 without
comb attachments|1, to cut the beard
very short or to cut a moustache and
hairline.
• Using the switch for cutting length fine
tuning|5 the cutting length can be varied
with five levels (0.5 mm / 1 mm /
1.5 mm / 2 mm / 2.5 mm).
• To trim your moustache, first comb it
straight downwards. Start at the centre
above the mouth and trim first one side,
then the other.
2 2.5
5 5.5 6
8 8.5 9
12
18
24
30