Tabla de contenido
Publicidad
F10
F11
34
English
9. Maintenance
• Plug manufacturers recommend replacing the plug
twice a year to avoid unexpected plug failure in a
job.
REPLACEMENT PLUG IS A NGK CMR7H.
IMPORTANT
• Note that using any spark plugs other than those
designated may result in the engine failing to
operate properly or in the engine becoming
overheated and damaged.
• To install the spark plug, first turn the plug until it is
finger tight, then tighten it a quarter turn more with a
socket wrench.
■ MUFFLER
WARNING
• Inspect periodically, the muffler for loose fasteners,
any damage or corrosion. If any sign of exhaust
leakage is found, do not use the blower and have it
repaired immediately.
• Note that failing to do so may result in the
engine catching on fire.
IMPORTANT
• Before starting operation, always make sure to
check if the muffler is properly held by three bolts to
the cylinder. (Fastening Torque : 70~110 kg·cm)
• Even if one bolt out of three bolts is loose, the
muffler may get loose during operation which may
result in engine catching on fire.
■ SPARK ARRESTER
• The muffler is equipped with a spark arrester to
prevent red hot carbon from flying out of the exhaust
outlet. Periodically inspect and clean as necessary
with a wire brush. In the State of California it is
required by law (Section 4442 of the California Pulic
Resources Code) to equip a spark arrester when a
gas powered tool is used in any forest covered, bush
covered, or grass covered unimproved land.
(1) Spark Arrester
Publicidad
Tabla de contenido
