Tramontina RC26B Manual De Uso página 14

• Before using the brushcutter, carefully read the user's and maintenance manual.
• Use good quality gasoline mixed with 4% (25/1) 2-stroke oil, and after using, do not leave gasoline
in the fuel tank.
Before beginning to trim, check the location where the brushcutter will be used and remove any
unusual objects, such as wires, stones, branches, etc.
• Do not use the brushcutter in the rain or under wet conditions.
• Check and clean the air filter before each use.
• Now that you are the owner of a Tramontina brushcutter, you will receive FREE TECHNICAL
SUPPORT from our network of authorized Tramontina service centers.
debris Guard Assembly
1. Remove both fastening screws (A).
2. Place debris guard (B) on the trimmer tube.
3. Place the half-moon bracket on the debris guard slot aligning the opening with the tube.
4. Tighten both large screws (A) on the debris guard. On models RC33B and RC43B also tighten the
smaller screw on the trimmer's tube.
Axle Assembly (Model RC26B)
1. Loosen handle (1) located next to the fitting (3), [Fig. 02].
2. Press lever (2) and carefully slide the axle (4) into the fitting, [Fig. 02].
3. Fit the handle catch (6) to the axle opening (5), [Fig. 03]. Then, tighten the handle to secure the assembly.
Handlebar Assembly
Rotate the handle counter-clockwise to loosen the clip. Install the handlebar within the clip and rotate
the handle again to tighten the assembly, [Fig. 04]. Make sure that the handle does not become
wrapped around the clip, [Fig. 05].
Cutting-line Head Assembly [Fig. 06]
1. Align the gearbox opening (A) with the notch (B) on the internal flange (C).
2. Insert the 4 mm L-wrench (1) in the opening of the gearbox.
3. Turn the axle by hand until it completely locks in place.
4. Position the nylon reel (E) rotating it counter-clockwise until it is tight enough to fasten the assembly.
Blade assembly [Fig. 07] (exclusively for models RC33B e RC43B)
1. Align the gearbox opening (A) with the notch (B) on the internal flange (C).
2. Insert the 4 mm L-wrench (1) in the opening of the gearbox.
2. Turn the axle by hand until it completely locks in place.
3. Position the cutting blade (E) on the internal flange (D), and then on the outer flange (F), protected
by screw (G) and washer (H), fastening by tightening the blade locknut (J) counter-clockwise using the
combined wrench that comes with the product.
Fueling
Use good quality gasoline mixed with 4% (25/1) 2-stroke oil in the fuel tank. The tank holds 500 ml.
14
QuiCk use guide
assemBly
[Fig. 01]
opeRation