Water Supply - Orien FS50OD Manual Del Usuario

To replace door on hinges:
1. Using a fiat screwdriver, remove the plug buttons from the screw holes opposite the
hinges, top and bottom. Set aside.
2. Remove the bottom hinge and place it on the opposite side at the bottom of the door.
3. Position the door on the bottom hinge.
4. Align the door on the bottom hinge and replace the top hinge and top hinge mat.
5. Replace top hinge cover.
6. Push the plug buttons into the original screw holes.
door
Water Supply
The water supply should be ready at the point of installation. The water supply pressure should
be a minimum of 15 psig with a static pressure not more than 80 psig. (A wall outlet directly
behind the ice machine will make installation easier.)
IMP OR TANT"
• All installations must be in accordance with local plumbing code requirements. Professional
installation is recommended.
• Make certain that the hoses are notpinched or kinked or damaged during installation.
• Check for leaks after connection.
Tools required: 1/2" open-end wrenches, Phillips screwdriver
Rear of unit
f'l°
Water inlet
Drain outlet
13