Connecting The Gas - Orbegozo FO 6000 Manual De Instrucciones

FO 6000
WARNING: Accessible parts can reach very high temperatures!
-
Keep out of children's reach.
-
WARNING: after use, turn off the burner immediately.
-
The surface where the gas cooker will be installed must be flat and high temperature resistant.
-
This appliance is not intended for use by persons (including children) with reduced physical, sensory or
-
mental capabilities or lack of experience and knowledge, unless they are supervised by a competent
person during its use.
Children should be supervised to ensure that they do not play with the appliance.
-
PRECAUTION: For safety reasons, never leave packaging materials (plastic bags, cardboard, polyethylene
-
etc.) within the reach of children.

CONNECTING THE GAS

In order to work, the stove must have:
1 bottle of gas (butane or propane), only bottled by Official Dealers, in accordance with the gas
-
indicated on the data plate.
1 pressure regulator approved and indicated on the data plate with following characteristics: 28-30
-
bar for butane and 37 mbar for propane.
1 flexible tube approved for gas, with a maximum length of 1.5 m.
-
2 screw clamps for the flexible tube.
-
Connect the flexible tube to the gas supply inlet on the stove and the regulator, ensuring the tightness by
means of the 2 screw clamps.
Place the bottle on a stable surface and assemble the bottle regulator. Make sure that the flexible tube does
not come into contact with the stove and that it is not subject to any twisting forces. After opening the
regulator, check there is no gas leak by applying soapy water with a brush on the joint of the flexible tube
with the cooker and the regulator. The appearance of bubbles means there is a gas leak. Never use a flame
to detect gas leaks.
The bottle replacement must be done far away from any source of flame.
IF YOU SMELL GAS:
Turn off the burner
-
Close the appliance gas supply (bottle tap)
-
Contact your gas supplier or specialized personnel.
-
MAINTENANCE (by qualified personnel)
- Before doing any type of work, the gas supply tap must be turned off.
- Verify the state of the flexible connection tube regularly and replace it whenever necessary (expiry date).
- To ensure proper functioning, once a year check the burner taps, if necessary, REPLACE THEM. After doing
this, you must check to see there is no gas leak.
9