Monacor WAP-5 Manual De Instrucciones página 7

Ocultar thumbs Ver también para WAP-5:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 14
ATTENTION Never connect the power
supply unit when non-re-
chargeable batteries have
been inserted in the ac-
tive speaker; the batteries
may leak or even explode!
2) For operation independent of the
mains, insert six batteries of size AA as
indicated in the battery compartment,
then close the battery compartment.
Batteries must not be placed
in the household waste; al-
ways take them to a special
waste disposal, e. g. collection
container at your retailer.
3) When the power supply unit / charger is
connected, the rechargeable batteries
will be recharged automatically. The
RECHARGE LED (2) will light up. When
the batteries have been fully recharged,
the LED will go out.
5 Operation
1) Tie the belt strap with the active speaker
around your waist.
2) Attach the microphone to the metal rod
of the head strap (fig. 2) and the cable
holder to the metal head strap (fig. 3).
3) Put on the headband microphone (fig. 4).
Adjust the microphone so that it is close
to your mouth.
4) Connect the microphone to the jack MIC
IN (4). To prevent accidental disconnec-
tion of the plug of the microphone, use
the cap nut to fasten the plug to the
jack.
As an alternative, connect an audio
player with line output (e. g. CD player
or MP3 player) to the jack AUX IN (3) to
reproduce music.
All rights reserved by MONACOR
ual may be reproduced in any form or by any means for any commercial use.
5) Switch on the unit with the volume
6) After operation, switch off the unit with
6 Specifications
Total output power
during operation
Power rating
during operation
Power supply: . . . . . . . ⎓ 12 V via charger /
Ambient temperature: 0 – 40 °C
Dimensions
(W × H × D): . . . . . . . . 190 × 90 × 55 mm
Weight (w/o batteries): 290 g
Type of microphone: . . electret microphone
Subject to technical modification.
INTERNATIONAL GmbH & Co. KG. No part of this instruction man-
®
control VOL (6) and adjust the desired
volume. The green POWER LED (5) will
light up.
the volume control VOL.
If the WAP-5 is not in use for a longer
period of time, disconnect the power
supply unit / charger from the mains
socket; even with the active speaker
switched off, the power supply unit /
charger will have a low power consump-
tion. If any batteries have been inserted,
remove them to prevent damage to the
unit in case of battery leakage.
with power
supply unit: . . . . . . . . 10 W
with batteries: . . . . . 8 W
with power
supply unit: . . . . . . . . 7 W
with batteries: . . . . . 6 W
power supply
unit provided and
connected to
230 V/ 50 Hz or
via 6 batteries of
size AA
7

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

0173200

Tabla de contenido