Application; Tube Bender Diameter - Refco HY-TELL Serie Manual De Instrucciones

English

3. Application

1. Cut the pipe to the correct length for bending.
2. Select the right size of the former and assemble it on the HY-TELL
3. Select the counterformers in the right size and assemble it on the HY-TELL. Turn
the written parts with the appropriate size towards the former.
4. The Angle Master can be positioned on the HY-TELL. The position is defined by
two pinch, magnets are intended for the necessary hold.
5. Place the matching tube in the formers.
6. Turn the rotary knob on the left to the stop clockwise.
7. Pump until the correct bending angle is reached. If the Angle Master on position,
the angle can be read comfortably.
8. Turn the rotary knob in counter-directing direction to relax the tool and remove
the curved tube.
9. Use the saved power for the next step.

3.1. Tube Bender Diameter

In the following table is a list of the diameter that supports the HY-TELL and the
matching metric equivalent.
inch
1/4''
5/16''
3/8''
1/2''
5/8''
3/4''
7/8''
4
corresponds to
mm
6.35mm
7.937mm
9.525mm
12.7mm
15.875mm
19.050mm
22.225mm
Instruction Manual HY-TELL
Can be used
for...
6mm
8mm
10mm
12mm
16mm
18mm
22mm