SKYLOTEC BEAMTAC 2.0 Instrucciones De Uso página 6

Depending on the situation, individual fall protection must be
observed even during set-up. The installation direction can be
chosen in accordance with Fig. 2. The working area (effective
direction of a fall) is within the radius shown in fig. 3 which extends
to 45° from the vertical. Any swing due to an ascent or descent
which is not vertical (45°) to the anchor (worst case direction of fall)
must be avoided at all costs.
max. 90°
Fig.3
Use of the beam clamp is only permitted for the purposes explained
in this document. No modifications must be made to the products.
Equipment subjected to a fall must be withdrawn from use
immediately. The general service life must, as part of the checks
carried out, be evaluated by specialist personnel on a case-by-
case basis. Based on the type of application, regular checks must
be carried out at least once a year by an expert or qualified
specialist personnel. Always clean with warm water (40°C) and a
mild soap solution, then rinse well with clear water, dry naturally
and keep away from direct heat. Only to be serviced by SKYLOTEC-
authorised service centres.
2.) BEAMTAC 2.0
The BEAMTAC 2.0 is an anchor point according to EN 795/B; CEN/
TS16415 for the use of two persons and has a type approval
according to ANSI / ASSE Z359.18-2017 for the use of one person.
In addition, the BEAMTAC 2.0 has been tested to BS 7985:2013
with 15 kN and thus can be used for "ROPE ACCESS WORK".
6 6