SKYLOTEC BEAMTAC 2.0 Instrucciones De Uso página 8

Clamping jaw
Clamping jaw
D-ring
1. Operate the locking rocker to shift the clamping jaw.
2. Set the beam clamp at 90° right-angle to the beam and apply
the clamping jaws to the beam flange.
3. Push clamping jaws evenly towards the D-ring in order to
secure the beam clamp (clamping jaws as far on the flange as
possible).istant as possible to the D-ring. The locking rocker
must always be locked into at least the last notch.
Have the position of the clamping jaws as equidistant as
possible to the D-ring. The locking rocker must always be locked
into at least the last notch.
4. When the locking rockers are not engaged, pull the clamping
jaws back so that the clamping jaws lock into the next possible
notch.
5. Then release the ball lock pin with the button, and with the
button pressed, insert it into the hole indicated with the arrow
(see section 'Marking') as a locking mechanism, ensuring that
the pin is fully inserted/locked in.
6. Move the beam clamp in all directions to check that it is not
possible to slip off the beam.
3.) Certificate of Identification and warranty
Information on the affixed labels corresponds to that of the supplied
product. The pre-printed table reflects the status of the certification
/ standards on the date of the instructions. The information recorded
on the product is binding.
a) Product name
b) Article number
c) Dimensions / length
d) Material
e) Serial no.
f) Month and year of manufacture
g 1-x) Standards (international)
h 1-x) Certificate number
i 1-x) Certification authority
j 1-x) Certificate date
8 8
Ball lock pin
Notch
Locking rocker Locking rocker