4. If the rear of the range lifts more than ½" (1.3 cm) off the floor without
resistance, stop tilting the range and lower it gently back to the floor. The range
foot is not engaged in the anti-tip bracket.
IMPORTANT: If there is a snapping or popping sound when lifting the range,
the range may not be fully engaged in the bracket. Check to see if there are
obstructions keeping the range from sliding to the wall or keeping the range foot
from sliding into the bracket. Verify that the bracket is held securely in place by
the mounting screws.
5. Slide the range forward, and verify that the anti-tip bracket is securely attached
to the floor or wall.
6. Slide range back so the rear range foot is inserted into the slot of the anti-tip
bracket.
7. Repeat steps 1 through 3 to ensure that the range foot is engaged in the anti-tip
bracket.
If the rear of the range lifts more than ½" (1.3 cm) off the floor without
resistance, the anti-tip bracket may not be installed correctly. Do not operate
the range without anti-tip bracket installed and engaged.
8. Move the range into its final location. Check that the range is level by placing a
level on the oven bottom.
NOTE: The range must be level for optimum cooking and baking performance.
9. If needed, use a wrench to adjust the height of the leveling legs until the range is
level from side to side and from front to back.
STEP 5 - COMPLETE INSTALLATION
1. Reconnect power at the circuit breaker or fuse box.
2. Turn on each element to check that it is heating correctly.
3. Turn on the oven to check that it is heating correctly.
NOTE: When the range has been on for 5 minutes, check for heat. If range is cold,
turn off the range and contact a qualified technician.
4. Check that the indicator lights on the control panel, and the interior oven lights
illuminate correctly.
If the range does not operate correctly, check the following:
•
Household fuse is intact and tight; or circuit breaker has not tripped.
•
Range is plugged into a grounded outlet.
•
Electrical supply is connected.
Contact a qualified electrician to verify the electrical supply.
23