Night Mode - Dyson pure hot+coollink Manual De Instrucciones

Night mode

The night mode will dim the display and run quietly, making it ideal for use while sleeping.
When night mode is enabled (indicated by an illuminated half
moon symbol in the bottom right corner of the display), the display
will dim and after 5 seconds will fade to off. The half moon symbol
remains illuminated.
If the appliance is not in auto mode, the airflow speed will reduce to level 4. When night mode is activated, if it is already below level 4, it will
remain the same. This can be manually changed if desired. The display will illuminate briefly, then fade as before. If in auto mode the airflow
speed will be reduced automatically.
Oscillation
Diffused and focused modes
54
Oscillation control
To start the appliance
oscillating, press the oscillation
control button. To stop the
appliance oscillating, press
it again. The appliance will
not oscillate when the control
buttons are pressed.
Diffused mode
Press the wide angle button
to change from a personal
directed airflow to wider
projection of air flow.
Heating and cooling modes
work in this mode.
5 secs
Airflow speed control
Airflow speed control
To change the airflow speed
press the airflow control button.
The digital display will show
the new fan speed. If in heater
mode after 2.5 seconds it will
change back to displaying the
target temperature.
Focused mode
Press the narrow angle button to
change from a wider projection
of airflow to a personal directed
airflow.
Heating and cooling modes work
in this mode.