Vortice ECODRY Manual De Instrucciones página 20

ENGLISH
Pre-drill the wall in the marked locations using a 5/16" (8mm) drill (fig. 5A), insert the plastic anchors and tap
flush to the wall. If the cable entry is to be done from the rear of the product provide a proper cable exit (5B).
5
8
INSTALLING THE POWER CABLE
WARNING: ENSURE POWER IS NOT CONNECTED (see wiring diagram fig. 16)
• Pull the cable through the grommet. Ensure the cable is long enough to route correctly through the backplate to
the terminal block.
• The cable must sit in the dedicated channel.
• As shown, connect cable to terminal block (fig. 6 - supply cable from below).
• Screw in terminal block.
• Fix the cable clamp with screw in the backplate.
CAUTION: Connect the ground wire to the terminal block marked "
Do not over-tighten and crush the power cable.
6A
20
A
CONNECTION TERMINAL BLOCK
ECODRY
6mm
Ø8 mm MAX PVC
B
".
L
N