Imit WPT V Manual De Instrucciones página 9

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 25
INSTALLATION
Place this device far from any heat source or air flow, at about a 1,5mt height from the floor. Open the
device pushing the clip on the base right side (Fig.1-1) then rotate the front cover leftward (Fig.1-2) and lift
slightly to unfasten it (Fig.1-3). Remove the two screws (Fig.2-D) fixing the inner protection cover for the
electrical connections. Rotate leftward and release it. Fix the base on to the wall, using the horizontal (Fig.2,
A-A or A-B) or the vertical (Fig.2, C-C) holes. Take care to dispose the cables in a proper manner through
the window on the bottom of the base. Connect the wires to the terminal block according to the schematics
(Fig.3) and place the protective inner cover again over the electric parts. Fix the screws (Fig.2-D). Dispose
the optional external probe cable separately from the relay thermostat connection wires. Insert the batteries
in their compartment on the display board as described (Fig.4). Close the device proceeding like in Fig.1,
reversing the operations order: match the left side of the two parts (Fig.1-3) then rotate the front cover
rightward (Fig.1-2) until the clip on the base clacks (Fig.1-1).
BATTERIES REPLACEMENT
When the battery symbol
on the display flashes (batteries out of power) take care of their replacement.
Please proceed as described in the installation instructions (Fig.2 and Fig.4). Re-assemble the front cover
back to the base before performing any operation on the control.
DESCRIPTION OF COMMANDS AND OPERATIONS (Fig.5)
Command keys are accomplished on a four position ring each one identified by the arrows ◄►▲▼, an
additional key in the middle, hereafter named OK and four keys more: Menu (Copy), Prog (Paste), Mode,
Esc. Press the ring exactly on the arrows to avoid multiple keys activations. Press OK key in the middle. Use
arrow keys to modify time and temperature values or select the available options. OK key is generally used
to confirm the settings.
Manuale WPT multilingue interno.indd 9
19/11/15 15:57

Publicidad

Tabla de contenido
loading

Productos relacionados para Imit WPT V

Este manual también es adecuado para:

Wpt

Tabla de contenido