Care And Maintenance; Cleaning Your Refrigerator; Power Failure; Moving Your Refrigerator - Avanti OBC32SS Manual De Instrucciones

SETTING THE TEMPERATURE CONTROL (MODEL OBC33SSD – ONLY)

The temperature range for your Beverage Center is 36º - 64ºF (2º-18ºC).

The default temperature set at the factory is 41ºF (5ºC). Once the unit is plugged in, the default
temperature will be displayed in the digital display window.

To adjust the temperature, press the SET button, then use the UP or DOWN buttons to select the
preferred temperature. When the selected temperature is shown in the display window of the
control panel, press the SET button to confirm the setting.

Once the temperature selection has been confirmed, the actual current temperature of the unit will
be shown in the DISPLAY window on the control panel.
depending on the amount of items stored and how frequently the door is opened.

In the event of a power outage, your unit is designed to remember the temperature setting and
will automatically return to that setting after the power has returned.
NOTE:

The temperature sensor monitors the average temperature of the unit. Cold air falls and warm air
rises, thus there will be a variation in temperature from the bottom to the top of the unit. The
bottom area of the unit will always be slightly cooler than the top area.

The temperature displayed in the control panel is an instantaneous average temperature of the
unit and there may be a variation of approximately 0 – 6ºF.

If the unit is unplugged, power lost, or turned off you must wait three (3) minutes before restarting
the unit. If you attempt to restart before this time delay, the refrigerator will not start.
 INTERIOR LIGHT
The interior light can be operated manually by pressing the Light ON / OFF button on the control
panel. The light will automatically turn itself OFF after 5 minutes.
NOTE:
Avoid extended use of the light as the heat generated by the light bulb can raise the interior
temperature of the unit and affect the temperature of the items stored.
You can switch temperature display setting from Fahrenheit to Celsius degree by pushing the UP
button and hold for 10 seconds. Fahrenheit or Celsius degrees will appear in the temperature display
window .
 CLEANING YOUR REFRIGERATOR

Turn off the power, unplug the appliance, and remove all items including shelves.

Wash the inside surfaces with a warm water and baking soda solution. The solution should be
about 2 tablespoons of baking soda to a quart of water.

Wash the shelves with a mild detergent solution.

Wring excess water out of the sponge or cloth when cleaning area of the controls, or any
electrical parts.

Wash the outside cabinet with warm water and mild liquid detergent. Rinse well and wipe dry with
a clean soft cloth.

Do not use steel wool or steel brush on the stainless steel. These will contaminate the stainless
steel with steel particles and rusting may occur.
 POWER FAILURE

CARE AND MAINTENANCE

13
The temperature shown will vary