Bresser Explore Scientific RDP1003 Manual De Instrucciones página 10

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

°C/°F SETTING
Press [
] button to switch Celsius (°C) / Fahr-
enheit (°F).
ALARM
SETTING/ADJUSTING DUAL ALARM TIME
You can set two alarm times (AL1 and AL2).
1. In standard mode, press [SET] button several times
until the display shows "AL1" or "AL2".
2. Press and hold [SET] button to enter the alarm set-
ting mode for the currently selected alarm (AL1 or
AL2).
3. The setting parameter will flash.
4. Press [+] or [-] button to set the desired data.
5. Press [SET] button to confirm setting and enter to
next parameter.
6. Sequence of setting: Hour  Minute  Exit
7. Alarm will turn on automatically when alarm setting
is finished.
8. If there is no action in 20 seconds, the setting will be
saved and will exit the setting mode.
10
TURN ON/OFF ALARM
1. In standard mode, press the [
on/off the alarm. The sequence is: AL1 on  AL2
on  AL1+AL2 on  AL1+AL2 off.
2. The AL1 default alarm time is 6:00 o'clock and the
AL2 default alarm time is 8:00 o'clock.
3. The alarm lasts 2 minutes and becomes faster and
faster over time.
OPERATION
1. At the set time, alarm signal rings.
2. During the alarm, press the [
lay the alarm by 4 minutes.
3. If you do not press any button to stop the alarm, it
will automatically turn off after 2 minutes.
4. To stop the alarm, press the [
5. The alarm will start again at the next alarm time,
unless you switch off the alarm function by press-
ing the [UP] button.
] button to turn
] button to de-
] button.

Publicidad

Tabla de contenido
loading

Tabla de contenido