Publicidad
Idiomas disponibles
Idiomas disponibles
SF 0640
1. Unscrew height adjustment nut and remove.
2. Put cover's base in outer tube and screw height adjustment nut.
3. Put outer tube on the base and screw by under the base the supplied screw.
4. Adjust the height with nut of outer tube.
5. Unscrew the nut of frontal motor housing.
6. Place rear grill with handle upwards on frontal motor housing, fixing in pins of it. Screw previous nut and
tighten it.
7. Insert blade in motor shaft and tighten blade's nut as it is shown in below picture.
8. Place frontal grill setting both grills with holding ring.
9. Tighten screw of holding ring to fix both grills.
10. Insert fan's body in inner tube.
11. Tighten the body's screw (18) to fix body to inner tube.
OPERATION
1. Plug the fan to mains.
2. Press ON/OFF button to connect the fan.
3. Press SPEED button to set Low, Middle or High speed.
4. Press MODE button (in remote control) to set normal, nature (this mode simulates the sea breeze,
changing the ventilation power from low to high) or sleep mode (this mode changes the ventilation power
softer than previous mode, even stopping sometimes).
5. Press TIMER button to start timer from 30 minutes to 7.5 hours. Each time you press button time will
increase in 30 minutes until 7.5 hours.
6. Press oscillating knob to activate oscillation function. Pull it to deactivate function.
7. Tilt adjustment: before to set tilt, turn off the fan. Air flow can be adjusted to up or down moving the fan's
head to up or down.
10
Publicidad
