Bresser EXPLORE SCIENTIFIC RDC3006 Manual De Instrucciones página 10

1. Press the [
2. Press and hold [
ting mode for the currently selected alarm
(Alarm 1).
3. The setting parameter will flash.
4. Press [ ] or [ ] button to set the desired
data.
5. Press [ ] button to confirm setting and
enter to next parameter.
6. Sequence of setting: Hour  Minute  Vol
H/L (Alarm volume)  Exit
7. Alarm will turn on automatically when alarm
setting is finished.
8. If there is no action in 20 seconds, the setting
will be saved and will exit the setting mode.
TURN ON/OFF ALARM
1. In alarm display mode, press the [
ton to turn on/off the current alarm. when
in calendar display mode, the sequence
10
] button to display Alarm 1.
] to enter the alarm set-
is: AL1 on  AL2 on  AL1+AL2 on 
AL1+AL2 off.
2. The alarm lasts 2 minutes and becomes
faster and faster over time.
OPERATION
1. At the set time, alarm signal rings.
2. During the alarm, press the [
ton to delay the alarm by 8 minutes.
3. If you do not press any button to stop the
alarm, it will automatically turn off after 2
minutes.
4. To stop the alarm, press [
button except SNOOZE.
5. The alarm will start again at the next alarm
time, unless you switch off the alarm func-
tion by pressing the [
] but-
RESET
Press RESET to return to the default settings.
] but-
] or any other
] button.