INTERTECHNO ITM-200 Manual De Instrucciones página 29

GB
Operating instructions
ITM-200
How to erase codes
To erase the encoding, proceed as above, but the OFF signal must be
transmitted.
That means when the slider is moved from ON to OFF the red LED will
flash 2x.
Or by moving the magnet to the OFF position.
Settings
Open or close to activate
Choose between ON/OFF or OFF/ON switching when opened or closed
(Fig. 3b)
If the ON signal should be sent when opened, the slider should be
placed in the ON position.
If the ON signal should be sent when closed, the slider should be placed
in the OFF position.
Switch-off feature (Fig. 3a)
At position 0, it will be turned on/off immediately when opened or
closed.
There are 3 automatic switch-off times available: 1 min/5 mins/10 mins.
The wireless magnet transmitter re-triggers.
This means that if the door is opened and closed during the pre-set time,
the countdown of the switch-off time begins from the last ON signal.
Mounting
The wireless receiver must be function tested before the transmitter
is permanently mounted using the included screws or double-sided
adhesive tape.
To mount with screws, remove the mounting plate from the transmitter
and magnets in advance and mount them in the places provided
(Fig. 4).
To avoid exposing the transmitter to unnecessary vibrations or shocks,
we recommend you attach it to the frame and attach the magnet to the
moving parts (windows).
The distance between the magnet and the transmitter should not
exceed 5 mm.
Slide on the transmitter again. Re-insert the magnet.
›