Makita MU04 Manual De Instrucciones página 13

1
► 1 . Screws
8. Place the undercover so that
cover is aligned with
9. While pressing the undercover, turn it clockwise
until on the undercover is aligned with
lever.
10. Make sure that the lock lever fits in the groove on
the undercover.
on the under-
on the lock lever.
on the lock
1
► 1 . Lock lever
CAUTION:
Never use the tool without install-
ing the undercover.
11. Remove the blade cover, and then turn on the tool
to check that it works properly.
NOTICE:
If the shear blades do not operate prop-
erly, the blades are not engaging the crank prop-
erly. Remove the blades and install them again.
Installing or removing the chip
receiver
Optional accessory
CAUTION:
When installing or removing the
chip receiver, always wear gloves and attach the
blade cover so that your hands and face do not
directly contact the blade.
The chip receiver gathers discarded leaves and makes
clean-up afterward much easier. It can be installed on
either side of the tool.
To install the chip receiver, press it against the shear
blades so that the hooks fit into the holes of the shear
blades.
► 1 . Hooks 2. Holes
To remove the chip receiver, press the levers on both
sides to release the hooks.
13 ENGLISH
1
2