Installation; Location; Door Handle Install Illumination(Optional) - CORBERO CC2100EDW Manual De Instrucciones

2. INSTALLATION

2.1 Location

When selecting a position for your unit you should make sure the floor is flat and firm, and the
room is well ventilated. Avoid locating your unit near a heat source, e.g. cooker, boiler or radiator.
Also avoid direct sunlight as it may increase the electrical consumption. Extreme cold ambient
temperatures may also cause the unit not to perform properly. This unit is not designed for use in
a garage or outdoor installation. Do not drape the unit with any covering.
When installing the unit, ensure that 10 cm of free space is left at both sides, 10 cm at the rear
and 30 cm at the top of the unit. This will allow cold air to circulate around the wine cooler and
improve the efficiency of the cooling process.

2.2 Door Handle Install Illumination(optional)

1) Take out the screw caps from the door 2) Put the handles into the screw holes and
handle holes. then hit them to fix .
2