Optional Accessory - Makita LS1219 Manual De Instrucciones

Table (B)
– Molding
position in
the figure
For inside (a)
corner
(b)
For outside (c)
corner
(d)
Example:
In the case of cutting 52/38° type crown molding for
position (a) in the above figure:
• Tilt and secure bevel angle setting to 33.9° LEFT.
• Adjust and secure miter angle setting to 31.6°
RIGHT.
• Lay crown molding with its broad back (hidden)
surface down on the turn base with its CEILING
CONTACT EDGE against the guide fence on the
saw.
• The finished piece to be used will always be on
the LEFT side of the blade after the cut has been
made.
In the case of right bevel cut
(a) (b)
1. Inside corner 2. Outside corner
Table (A)
– Molding Bevel angle
position
52/38°
in the
type
figure
For (a) Right
inside 33.9°
corner
(b)
For (c)
outside
(d)
corner
Molding Finished
edge against piece
guide fence
Ceiling Finished
contact edge piece will be
should be on the Left
against guide side of blade.
fence.
Wall contact
edge should
Finished
be against
piece will be
guide fence.
on the Right
Ceiling side of blade.
contact edge
should be
against guide
fence.
(c) (d)
1 2
Miter angle
45° type 52/38°
type
Right Right
30° 31.6°
Left
31.6°
Right
31.6°
Table (B)
–
For inside
corner
For outside
corner
Example:
In the case of cutting 52/38° type crown molding for
position (a) in the above figure:
• Tilt and secure bevel angle setting to 33.9° RIGHT.
• Adjust and secure miter angle setting to 31.6°
RIGHT.
• Lay crown molding with its broad back (hidden)
surface down on the turn base with its WALL
CONTACT EDGE against the guide fence on the
saw.
• The finished piece to be used will always be on
the RIGHT side of the blade after the cut has been
made.
Crown molding stopper

Optional accessory

Crown molding stoppers allow easier cuts of crown
molding without tilting the saw blade. Install them on the
turn base as shown in the figures.
At right 45° miter angle
► Fig.49: 1. Crown molding stopper L 2. Crown mold-
At left 45° miter angle
► Fig.50: 1. Crown molding stopper L 2. Crown mold-
Position crown molding with its WALL CONTACT EDGE
against the guide fence and its CEILING CONTACT
EDGE against the crown molding stoppers as shown in
the figure. Adjust the crown molding stoppers according
to the size of the crown molding. Tighten the screws to
secure the crown molding stoppers. Refer to the table
(C) for the miter angle.
► Fig.51: 1. Guide fence 2. Crown molding stopper
45° type
Right
35.3°
Left
35.3°
Right
35.3°
26 ENGLISH
Molding Molding
position in edge against
the figure guide fence
(a) Wall contact
edge should
be against
guide fence.
(b) Ceiling
contact edge
(c)
should be
against guide
fence.
(d) Wall contact
edge should
be against
guide fence.
ing stopper R 3. Turn base 4. Guide fence
ing stopper R 3. Turn base 4. Guide fence
Finished
piece
Finished
piece will be
on the Right
side of blade.
Finished
piece will be
on the Left
side of blade.