Maintenance; Repairs; Warranty - DeWalt DW708 Manual De Instrucciones

MAINTENANCE

Removing and Replacing Belt
The belt is designed to last the life of the tool. However, abuse
of the tool could cause the belt to fail. If the blade does not
turn when the motor is running, the belt has failed. To inspect
or replace the belt, follow these directions:
1. Remove the belt cover screw.
2. Remove the belt cover. Inspect the ribs of the belt for wear
or failure. Check belt tension by squeezing the belt as
shown in figure 37. The belt should contact the center
boss when it is squeezed firmly with the thumb and index
finger.
3. To adjust the tension, loosen, but do not remove, the four
screws shown (figure 37). Rotate the set screw on the top
of the motor plate casting until the proper tension is
achieved. Tighten the six screws securely and replace
the belt cover.
NOTE: Overtightening the belt will cause premature motor
failure.
• All bearings are sealed ball bearings. They are lubricated
for life and need no further maintenance. Do not use WD-
40 or any other lubricant.
• Periodically clean all dust and wood chips from around the
area of the saw. Even though slots are provided to allow
debris to pass through, some dust will accumulate.
FIG. 37
SCREWS
CENTER BOSS
• The brushes are designed to give you several years of
use. If they ever need replacement follow the instructions
on page 8 or return the tool to the nearest service center
for repair. Service center locations are packed with your
tool.

Repairs

To assure product SAFETY and RELIABILITY, repairs,
maintenance and adjustment (including brush inspection
and replacement) should be performed by authorized service
centers or other qualified service organizations, always using
identical replacement parts.
Three Year Limited Warranty
D WALT will repair, without charge, any defects due to faulty
E
materials or workmanship for three years from the date of
purchase. This warranty does not cover part failure due to
normal wear or tool abuse. For further detail of warranty
coverage and warranty repair information, visit
www.dewalt.com or call 1-800-4-D
This warranty does not apply to accessories or damage
caused where repairs have been made or attempted by
others. This warranty gives you specific legal rights and you
may have other rights which vary in certain states or
provinces.
In addition to the warranty, D
our:
D WALT will maintain the tool and replace worn parts
E
caused by normal use, for free, any time during the first year
after purchase.
SET
90 DAY MONEY BACK GUARANTEE
SCREW
If you are not completely satisfied with the performance of
your D WALT Power Tool, Laser, or Nailer for any reason,
E
you can return it within 90 days from the date of purchase
with a receipt for a full refund – no questions asked.
FREE WARNING LABEL REPLACEMENT: If your warning
labels become illegible or are missing, call 1-800-4-D
for a free replacement.
WALT (1-800-433-9258).
E
WALT tools are covered by
E
1 YEAR FREE SERVICE
WALT
E
15