Utility Routing Channel Location - Whirlpool WDF518SAHW0 Instrucciones De Instalación

UTILITY ROUTING CHANNEL LOCATON
18.
Water supply hose, power cord
channel routing locations
Route water supply hose
and electrical supply through
the channels in the bottom
of base as shown.
Fill valve
Channels
Hose
Route the water supply and electrical supply to the back of the
unit through the bottom base channels provided. Secure utilites
in channel using tape or wire ties.
WARNING
Excessive Weight Hazard
Use two or more people to move and install
dishwasher.
Failure to do so can result in back or other injury.
19.
Stand dishwasher upright
Using two or more people, stand the dishwasher up.
NOTE: Do not install kick plate until instructed to do so.
Dishwasher may fit tightly into cabinet opening. Do not remove
insulation blanket—the blanket reduces the sound level.
NOTE: Route water supply, drain hose, and power cord out the
rear of the dishwasher.
Junction box
Electical cord
20.
Move dishwasher close
to cabinet opening
Water
Route the utilities through the holes in the cabinet, and pull
the slack out at the same time as the dishwasher is pushed into
the cabinet
21.
Route power cord
If using a power cord, make sure to route the end through hole
in cutout before sliding dishwasher into the cabinet opening.
22.
Secure insulation blanket
Insulation
blanket
NOTE: Make sure insulation blanket is secured at both left and
right rear corners before pushing into cabinet opening to keep
the blanket from bunching up in a tight fitting cabinet.
line
Drain
Cable
Secure
blanket
13