Cleaning And Maintenance; Troubleshooting - Valueline VLS-DVBS2-FTA1 Manual De Usuario

"Multimedia"

Troubleshooting

If you cannot solve the problem, contact your dealer.
Problem
No sound.
No picture.
The image stops or looks like mosaic.
The screen shows the message "No
Signal".
The remote control does not work.
"Multimedia":
1. Press the up/down buttons to
select different files.
2. Press the OK button.
3. Use the buttons on the remote
control to play the multimedia.
Colour buttons:
1. When the picture is shown, press
the red button in zoom mode to
switch between preview and
fullscreen.
2. Press the green mode to rename
the PVR file on the PVR playback
page.
3. Press the yellow mode to delete
the PVR file on the PVR playback
page.
4. Press the blue button to enter grid
show mode.
Possible cause
No or incorrect audio cable connection.
The sound is muted.
The device plays an incorrect sound track.
The mains plug is not inserted into the wall socket.
The device is switched off.
The signal is too weak.
The antenna cable is not connected.
Incorrect settings.
The batteries are low.
The remote control is not pointing to the device.
8 8

Cleaning and maintenance

Warning!
• Before cleaning or maintenance, switch off the device,
remove the mains plug from the wall socket and wait
until the device has cooled down.
• Do not use cleaning solvents or abrasives.
• Do not clean the inside of the device.
• Do not attempt to repair the device. If the device does
not operate correctly, replace it with a new device.
• Clean the outside of the device using a soft, damp
cloth. Thoroughly dry the outside of the device with a
clean, dry cloth.
Solution
Connect the audio cable correctly.
Unmute the sound.
Change the sound track.
Insert the mains plug into the wall socket.
Switch on the device.
Strengthen the signal.
Connect the antenna cable.
Change the settings.
Replace the batteries.
Point the remote control to the device.
Make sure that nothing blocks the front panel.
English