Putting Into Operation - Kränzle K 1050 TST Manual De Instrucciones

Putting into operation

1.
2.
3.
4.
When carrying the K 1050 TST, make sure to bear in mind the weight
of the high pressure cleaner (see technical data).
Neither set up or operate the K 1050 TST in rooms where there is a risk
of fire or explosion nor put it into puddles. Do not use the high pres-
sure cleaner under water. If, none the less, the high pressure cleaner is
operated in a hazardous area, the applicable safety regulations are to
be observed.
42
Use the supplied screws to fasten the
lower cable retractor of the power
supply cable in the place provided on
the frame.
Set up high pressure cleaner. Plug the
hand crank onto the hexagon and
attach it with the enclosed screw and
washer.
Move high pressure cleaner to the job
site. The K 1050 TST is a movable high
pressure cleaner with sturdy trolleys
ideally suited for difficult terrain and
stairs.
Owing to its light weight and handy
size, the K 1050 TST can be easily
carried by two persons.
Putting into operation
Prior to insertion, check plug coupling connection of lance for clean-
liness (sand, dirt ..) and use clear water to clean, if necessary.
Impurities may damage the sealing in the plug coupling.
5. Unwind high pressure hose straight
and without nooses. Completely
unwind hose. (When using high pres-
sure hose extensions take care that the
max. length of 20 m is not exceeded!)
6. Tightly screw together high pressure
hose and safety trigger gun.
7. First pull back the retaining sleeve
of the safety trigger gun, then
insert lance into the plug coupling
sconnection of the safety trigger gun.
8. After insertion of the lance, release
retaining sleeve and make sure that the
lance is in a secure position.
GB
43