Technical Data; Installation - Zanussi ZRB629W Manual De Instrucciones

Problem
The lamp does not work.
If your appliance is still not working properly after making
the above checks, contact the After Sales Centre.
Replacing the lamp
1. Disconnect the appliance.
2. Push the movable part to unhook the lamp cover (1).
3. Remove the lamp cover (2).
4. Replace the lamp with one of the same power and
specifically designed for domestic appliances only.
5. Install the lamp cover.
6. Connect the appliance.
7. Open the door. Make sure that the lamp comes on.

Technical data

Dimension
Height
Width
Depth
Rising Time
Voltage
Frequency
The technical information are situated in the rating plate
on the internal left side of the appliance and in the energy
label.

Installation

Caution! Read the "Safety Information" carefully for
your safety and correct operation of the appliance
before installing the appliance.
Possible cause
The appliance has no power. There is
no voltage in the mains socket.
The lamp is in stand-by.
The lamp is defective.
ZRB629W
1540 mm 1750 mm
595 mm 595 mm
658 mm 658 mm
20 h 20 h
230 V 230 V
50 Hz 50 Hz
Connect a different electrical appliance
to the mains socket. Contact a qualified
electrician.
Close and open the door.
Refer to "Replacing the lamp".
1
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Con-
tact the Service Center.
ZRB634W ZRB636W
1850 mm
595 mm
658 mm
20 h
230 V
50 Hz
Positioning
Install this appliance at a location where the ambient tem-
perature corresponds to the climate class indicated on the
rating plate of the appliance:
Solution
2
ZRB640W
2010 mm
595 mm
658 mm
20 h
230 V
50 Hz
19