Standard Equipment; Preparing The Machine For Operation; Assembling The Handlebar; Installing The Grass Catcher Box - Viking LE 240 Manual De Instrucciones

6. Standard equipment

Item Designation
A Basic machine with scarify-
ing unit fitted
B Grass catcher box frame
C Grass catcher box
D Centre handlebar section
E Aerator roller
F Rotary handle
G Bolt
H Washer
I Cable guide
J Bracket
K Tool unit bolt
−
Allen key
−
Instruction manual
7. Preparing the machine for
operation
Risk of injury!
Observe the safety instructions in
the section "For your safety". (
Follow the instructions in the
section "Transporting the machine"
when lifting the scarifier out of the
packaging. In particular, wear
gloves and avoid contact with the
blades/spring-tines. (
● Place the machine on level and firm
ground when performing all the
operations described.
0478 670 9905 A - EN

7.1 Assembling the handlebar

● Open the quick-clamping
devices (1) and fold the lower
handlebar (2) rearwards. Hold it at the
2
desired height and close the quick-
clamping devices again.
Qty.
● Fasten the two centre handlebar
1
sections (D) to the lower handlebar (2)
as illustrated. To do this, insert the
1
bolts (G) in the holes provided from the
1
outside, place the washer (H) on the
2
inside and then fasten everything using
1
the rotary handles (F). A cable guide (I)
4
is also attached on the outside on the
right.
4
4
● Then assemble the upper handlebar (3)
in the same way on the centre
2
handlebar sections (D).
1
● Finally press the electric cable (4) into
2
the cable guides (I).
1
1
7.2 Installing the grass catcher
box
● Pull the grass catcher box (1)
with the base plate downwards over the
grass catcher box frame (2) as
illustrated. The handle (3) must be on
4.)
the outside of the box.
● Position the integrated plastic
profiles (4) on the grass catcher box
frame and press into place.
● Attach the grass catcher box. (
4.4)

7.3 Replacing the scarifying

unit/aerator roller

– Switch off the motor and
disconnect the mains plug. (
– Place the machine in the cleaning
position. (
3 Removing the scarifying unit/aerator
roller:
● 1 Unscrew the bolts (1) on the right
side of the machine using the Allen key
(included in standard equipment).
● 2 Lift the scarifying unit/aerator
roller (2) on the right side.
● 3 Pull out on the left side.
Installing the scarifying unit/aerator
roller:
The bolts (1) must be replaced
every fifth time the scarifying
unit/aerator roller is installed and
removed. Your VIKING specialist
dealer can provide you with spare
parts.
● Attach the bracket (3) to the bearing (4)
at the end of the scarifying unit/aerator
roller (2).
● Insert the scarifying unit/aerator roller
into the protruding shaft.
4
● Press the other end of the scarifying
unit/aerator roller together with the
bracket (3), with the flat side facing out,
into the bracket on the machine.
● Insert the bolts (1) and tighten.
7.5)
5
10.4)
11.2)
35