Rearpanel - Omnitronic EX-840 Manual Del Usuario

When you set the CUE MIXING-fader to PGM (CUE-buttons without function), you can cue the output
signal of the mixer.
When you set the CUE MIXING-fader to to the center position, you can cue both the channel-signal you
selected and the output-signal.
(37) CUE SPLIT/CUE MIX BUTTON
Cue Split-function (button pressed): the Cue-signal is on the one side of the headphones and the output-
signal on the other side.
Cue Mix-function (button released): the adjustable mix of Cue-signal and output-signal is on both sides
of the headphones.
(38) CUE LEVEL-CONTROL
With the Cue Level-control, you can adjust the phones volume without changing the output signal.
(39) HEADPHONES SOCKET
Use this socket to connect the headphones. Headphones from 8 Ohms to 600 Ohms can be used.

5.2 Rearpanel

(40) MIC 2-SOCKET
Connect your microphone with ¼" jack plug here.
(40) MIC 3-SOCKET
Connect your microphone with ¼" jack plug here.
(42), (43), (44) LINE / PHONO / AUX INPUT-SOCKETS
Input socket for CH-1, CH-2 and CH-3. Connect turntables equipped with MM pickup cartridge to PHONO
input. CD players or Tape Decks should be connected to LINE input. Line level musical instruments with
stereo outputs such as Rhythm Machines or Samplers should also be connected to LINE inputs.
GND (Ground terminal)
Connect the ground lead of the turntable with this terminal. This helps to reduce humming and pop noises.
(45) LINE 4 INPUT-SOCKETS
Input socket for CH-4.
(46) REC OUT
To connect your recording unit.
(47) ZONE OUT
Connect your monitor system here.
(48) MASTER OUT
Output sockets for connecting your power amplifier.
(49) X-START-SOCKETS
Via the Start-socket, the respective CD-player can be remotely controlled via the Crossfader. If you are using
a CD-player with Faderstart-function connect the mixer with the Control-socket. Please note that these
sockets must never be connected with any voltage.
(50) DIGITAL OUT-SOCKET
The music-signal of this socket is digital. Connect the output to the respective input of a digital amplifier for
example.
(51) TRIM CONTROL
For adjusting the digital signal output.
(52) BALANCED MASTER OUTPUT
Balanced output for the master signal.
(53) VOLTAGE SELECTOR
Make sure that the indication corresponds to the available voltage.
(54) AC CONNECTION
Plug the power supply cable in here.
25/47 10007050_V_1_1.DOC