dirna Bergstrom bycool PASCAL Instrucciones De Montaje página 6

PASCAL
EN
Assembly
Recommendations
• Before starting assembly, please read instructions and
follow them during installation process.
• Use the adequate tools for each operation.
Electricity
• Disconnect ignition key.
• Disconnect battery before starting assembly.
• Make sure electric components are securely connected,
checking their correct fitting.
Piping
• Ensure the refrigerant conduit sleeves are secure and do
not come into contact with sharp or very hot elements.
• Take particular care when making the boreholes and
cutting, making sure there is no damage to the electric
cables or the fuel conduits.
• All the couplings must be clean, applying a small
amount of the same oil as used for the compressor
before tightening them.
• Always tighten the couplings using 2 wrenches to
prevent any breakage.
Tightening torque (N∙m)
Steel quality
Thread
8.8
M6/100 10
M8/125 22
M10/150 45
Tightening torque (N∙m)
Coupling
3/8
1/2
5/8
Torque
10.9
13 10
30 13
61 17
Nut Torque
5/8 15-17
3/4 15-17
7/8 24/27
Ø35 Circular saw
Bore
Ø4, Ø6, Ø9 Broaches
10, 13, 17, 19, 22, 24 Wrench
Scissors
Flexo-meter
Documentation included
Mounting instructions
User's guide
Parts list
Fragile
Beware of cuts!
Electrical hazard
!
The installing personnel must have a sufficient training
in vehicles air conditioning.
!
dirna Bergstrom, s. l. shall not be responsible for
breakdowns or damages coming from an inadequate
handling or installation of the equipment or from
modifications and substitutions carried out without
our express and written authorisation.
!
Please see product warranty procedure included in
Troubleshooting diagnosis.
!
Please see equipment User's Guide for its correct
functioning of the remote control and control panel.
!
Once installation is finished, the following documents
must be handed over to the user: User's Guide,
Warranty and Troubleshooting Diagnosis.
!
The unit does not comply with ADR regulations.
6
Tools
1001324242
220AA10005
1001324245
Symbology
! Warnings
®