Wall Evaporador - dirna Bergstrom bycool PASCAL Instrucciones De Montaje

PASCAL
EN
EVAPORATOR
1- Mount evaporator
6/100x15 screws.
2- Place evaporator unit in the most suitable
area of the cabin (ceiling, floor, dashboard,
wall, etc ...).
3- Mark evaporator fastening points.
4- Make holes of Ø 7, if they are to be through
holes or Ø 9 if M6 rivet nuts are to be used.
5- Fix evaporator with (4) 6/100x15 screws with
grower washers and flat washers if M6 nuts
rivet are used and with (4) 6/100x25 screws
if they are through holes (if secured to the
ceiling it should be fastened by inserting
screws with flat and rubber washers on the
outside of the cabin and fixed inside with flat
washers and M6 nuts, this is done to avoid
water entering the cabin).
1
2- Roof evaporator
2- Floor evaporator
brackets with (4)
1

WALL EVAPORADOR

8
®
5