Before Setting Oven Controls; Setting Oven Controls - Kenmore 790 Manual Del Usuario

Before Setting Oven
Controls
Oven Vent Location
The oven vent is located below the
backguard. When the oven is on,
warm air is released through the vents.
This venting is necessary for proper air
circulation in the oven and good baking
results.

Setting Oven Controls

Note: The oven function will not work
if the time of day clock is not set.
Note: The oven control has a built-in
safety feature that will shut off the oven
if the control is left on for more than 11
hours 59 minutes.
Arranging Oven Racks
(Some models may have one rack.) ALWAYS ARRANGE OVEN RACKS
WHEN THE OVEN IS COOL (PRIOR TO OPERATING THE OVEN). Always
use oven mitts when using the oven.
REMOVING & REPLACING OVEN
RACKS
To remove, pull the rack forward until it
stops. Lift up front of rack and slide out.
To replace, fit the rack onto the guides
on the oven walls. Tilt the front of the
rack upward and slide the rack back
into place.
To Set or Change the Temperature for Normal Baking
The oven can be programmed to bake at any temperature from 170°F to
550°F (65°C to 287°C).
To Set the Controls for Normal Baking:
1. Push . "— — —" appears in the display.
2. Within 5 seconds, push the
(177°C)." By holding the
adjusted in 5°F (1°C) increments.
3. As soon as the
the selected temperature. When the displayed temperature reaches the
desired baking temperature, the control will beep 3 times.
4. To cancel the baking function, push
To Change the Oven Temperature after Baking has Started:
1. If you are using the minute timer, push
temperature is displayed.
2. Push the or
11
ARRANGING OVEN RACKS WITH
5 RACK POSITIONS
To bake on 1 rack, place the rack on
position 3 or 4. To bake on 2 racks,
place the racks on positions 2 and 4.
or . The display will show "350°F
or , the temperature can then be
or is released, the oven will begin heating to
.
and make sure the bake
to increase or decrease the set temperature.