Unpacking And Connecting; Unpacking; Assembly - Dirt Devil Infinity V12 Manual De Instrucciones

02_Infinity_gb.book Seite 26 Donnerstag, 29. Januar 2009 12:56 12

2 Unpacking and connecting

2 Unpacking and connecting

2.1 Unpacking

2.2 Assembly

1 2
4
1
3
2
1
a
26
Unpack the appliance and all accessory parts and check
that the contents are complete. Information regarding the
scope of delivery
V12".
ATTENTION:
Always transport/send the appliance in its original
packaging so that it does not become damaged. Keep
the packing material for this purpose.
Dispose of any packing material that is no longer
required in accordance with the provisions applicable in
your country.
NOTE:
If you should notice damage due to transport, then
contact your dealer immediately.
WARNING:
Only assemble the appliance if the plug has been pulled
out of the socket. It could be switched on by accident.
1. Plug the suction hose adapter (Fig. 2/1) into the suction
hose receiver (Fig. 2/2) and lock the adapter by turning
it clockwise to the stop point.
2. Push the handle (Fig. 3/1) into the upper end of the
telescopic tube (Fig. 3/2).
Fig. 2
3. Push the floor nozzle (Fig. 3/3) onto the lower end of the
telescopic tube (Fig. 3/4).
NOTE:
It may be necessary to push a bit harder.
4. Adjust the length of the telescopic tube. To do this,
press the telescopic tube lock (Fig. 4/1) forwards
(Fig. 4/a). Then pull the telescopic tube by the handle to
Fig. 3
the desired length (Fig. 4/b). To lock it, release the
telescopic tube lock while you pull. You will hear an
b
audible click.
Your cylinder vacuum cleaner is now ready to use.
Fig. 4
Page 22, "An overview of your Infinity