Remote Control Handset; Inserting Batteries; Switching On/Off; Input Selection - Saba SBV1943H Instrucciones De Manejo

• When the connection is made, switch to
See, Input selection section.
• You may also connect through the
Scart Cable
(not supplied)
External device
• Note : These three methods of connection perform the
same function but in different levels of quality. It is not
necessary to connect by all three methods.

Remote Control Handset

Inserting Batteries

• Remove the battery cover located on the back of
the handset by gently pulling backwards from the
indicated part.
• Insert two AAA/R3 or equivalent type batteries
inside. Observe the correct polarity (+/-) when
inserting batteries and replace the battery cover.
Note: Remove the battery from remote control
handset when it is not to be used for a long period.
Otherwise it can be damaged due to any leakage of
batteries. Remote range is approximately 7m/23ft.
YPbPr source.
To Switch the TV On
SCART input.
•
•
•
•
Note: If you switch on your TV via PROGRAMME
UP/DOWN buttons on the remote control or on the
TV set, the programme that you were watching last
will be reselected.
By either method the TV will switch on.
To Switch the TV Off
•
•
Note: When the TV is switched to standby mode,
standby LED can blink to indicate that features such
as Standby Search, Over Air Download or Timer is
active.
Once you have connected external systems to
your TV, you can switch to different input sources.
Press "SOURCE" button on your remote control
consecutively for directly changing sources.
Note: YPbPr mode can be used only when you
connect a device that has a YPbPr output through the
PC input with YPbPr to PC cable (not supplied).
English - 54 -

Switching On/Off

Connect the power cord to the 220-240V AC 50 Hz.
Then the standby LED lights up.(The led will blink
during the standby On/Off)
To switch on the TV from standby mode either:
Press the " " button, CH " " / CH " " or a numeric
button on the remote control.
" button, - or + button on the TV. The
Press the "
TV will then switch on.
Press the " " button on the remote control or press
the " " switch on the TV, so the TV will switch to
standby mode.
To power down the TV completely, unplug the
power cord from the mains socket.

Input Selection