Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE
First check whether your ceiling fan is suitable for operation with a remote control.
Before starting installation, make sure that any pull switch on the ceiling fan is set to the highest
position. Damage to the electronics of the receiver unit of the remote control and the fan will not be
covered by the warranty if this is not observed!
This remote control can be encoded 16 times. The micro-switches shown must be set identically in the
battery compartment of the remote control and on the remote control receiver so that the transmitter
and receiver can communicate (Fig. 1). This allows you to pair multiple receivers with one transmitter or
multiple transmitters with one receiver.
After changing the encoding, the batteries must be removed and replaced for the change to take effect.
ON
-
+
-
+
+
-
+
-
Assembly
Slide the remote control receiver into the mounting bracket as shown in Fig. 2. Make sure that no cables
are squeezed or damaged!
Fig. 2
ON
EN
Fig. 1
11
Publicidad
