Reiner jetStamp graphic 970 Manual De Instrucciones página 73

jetStamp graphic 970
The barcode window is structured in 3 areas:
Barcode
Type
Character sequence
Plain text preview
Parameter
Display plain text
Display check digit
Start and stop
characters:
Barcode size
Height (mm)
Module height
Module width
(pixels)
Module ratio X:1
Module ratio
(2/5 matrix)
Select the barcode type from the dropdown list.
Enter your desired character sequence.
Indicates the character sequence without control characters.
Inserts plain text below the barcode. The plain text is the character
sequence that you have entered into the barcode object.
Indicates the check figure additionally in plain text. To be able to
use this option, you need to activate display plain text. The check
figure is the last digit or position of the barcode information.
Start and stop characters from A-D for the barcode
coda bar.
Barcode height. Can be set from 3.5 mm - 13.5 mm.
Height of the narrowest element in pixels (stroke or gap).Only for
2D barcodes.
Width of the narrowest element in pixels (stroke or gap).
Ratio of wide to narrow element in calculation of the code length.
Start and stop characters for the barcode type coda bar. May con-
tain letters A-D.
GB
71