Descargar Imprimir esta página

Setup And Installation - Ebac SlimCool BN22 Serie Manual Del Usuario

Publicidad

Idiomas disponibles

Idiomas disponibles

Setup and Installation - Cook and Cold
New watercoolers are supplied from the factory with the
watertrail fitted
1. Remove red cap from the manifold spike (see dig 1)
2. Remove the cover from the outlet nozzle. (see dig 2)
3. Remove the cardboard insert from the taps.
4. Connect the cooler to the power supply.
5. (Remove label from the bottle cap)
Fit a water bottle onto the cooler. (Water can be
dispensed only after the watertrail has filled which may
take 1-2 minutes after bottle is fitted).
6. The cup stand can be adjusted up/down by pressing
the cup stand trigger and sliding the stand in the
required direction.
7. To dispense water from the cooler place a cup on the
cup stand and press the left tap for ambient water or
the right tap for cold.
The watercooler has been successfully installed.
Watertrail replacement
1. Remove the water bottle from the cooler and place a cup
on the cup stand
2. Open both taps until the water stops dripping and unclip
the lid. (see dig 1)
3. Open the lid fully and remove the watertrail (see dig 2)
4. Remove the new watertrail from the sealed protective
sleeve
5. Fit the watertrail into the cooler and close the lid.
6. Remove the cover from the outlet nozzle as shown in

setup and installation

7. Ensure the lid is locked into position and replace the
water bottle.
DE ES FR
GB 4
Red Sealing Cap
Outlet
Nozzle Cover
Diagram 1
Lid Catch
Diagram 1
Diagram 2
Diagram 2

Publicidad

loading