Publicidad
Idiomas disponibles
Idiomas disponibles
EN
To start cooking
1.
Touch the ON/OFF (6) for 3 seconds. After power on, the buzzer beeps once, all
displays show "– ", indicating that the induction hob has entered the state of
standby mode.
2.
Place a suitable cookware on the cooking zone that you wish to use. Make sure
the bottom of the cookware and the surface of the cooking zone are clean and dry.
3.
According to the cooking zone where the cookware is placed, press the desired
zone selector (4).The symbol "0." selected will flash.
4.
Select the power level by pressing the "+"or "-" of the regulator (3).
5.
The power level will start at 5. Pressing the "+" will count up the power levels from
5 to 9 in numerical order. Pressing the "-" will take the power straight from 0 to 9.
6.
If you don't choose a power setting within 20 seconds, the induction hob will
automatically switch off. You will need to start again at step 1.
•
You can modify the power setting at any time during cooking.
If the display flashes alternately with the power setting
This means that:
• The cookware is not placed on the correct cooking zone or,
• The cookware is not suitable for induction cooking or,
• The cookware is too small or not properly centred on the cooking zone.
No heating takes place unless there is a suitable cookware on the cooking zone.
The display will automatically turn off after 1 minute if no suitable cookware is placed
on it.
When you have finished cooking
1.
Touch the zone selector (4) that you wish to switch off.
2.
Press "-" of the regulator and the power will decrease to "0" level, or press the
"+" and "-" at the same time and the power level will decrease to 0 straight away.
3.
Beware of hot surfaces
Publicidad
