Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Failure Display and Inspection
If an abnormality comes up, the induction hob will enter the protective state
automatically and display corresponding protective codes. These are the most common
failures:
Error
Message
No cookware or cookware not
suitable.
Water or cookware on the glass
ER03
over the control area.
Connection between the display
board and the left mainboard fails
F1E
(the cooking zone which indicator
shows "E").
Coil temperature sensor failure. (in
F3E
the cooking zone which indicator
shows "E").
Mainboard temperature sensor
F4E
failure. (in the cooking zone which
indicator shows "E").
Temperature measured by the
E1E
sensor of the ceramic glass is too
high.
Temperature sensor of the IGBT is
E2 E
too high.
Abnormal supply voltage (too
E3 E
high).
E4 E
Abnormal supply voltage (too low).
Temperature sensor failure (in
E5 E
the cooking zone which indicator
shows E").
Possible causes
What to do
Replace the cookware.
Clean the control area.
1.Connection cable not correctly
plugged or defective.
2.Replace the mainboard.
Replace the coil sensor.
Replace the mainboard.
Please restart after the hob has
been cooled down.
Please restart after the hob has
been cooled down.
Please inspect whether power
supply is normal. Switch on after
the power supply is normal.
Please inspect whether power
supply is normal. Switch on after
the power supply is normal.
Connection cable not correctly
plugged or the assembly is
defective.
Publicidad
