Abus FURM35000A Manual De Instrucciones página 44

Testing the device electronics
Regularly check the functionality of the smoke
alarm device by pressing the Test button. The
warning tone signals and the red "ALARM" LED
flashes.
This does not indicate that smoke is present in
the air in the room; it is a confirmation that the
smoke alarm device is functioning properly.
Test the functionality of the detector after installation without fail.
A regular test is also recommended.
Keep the device at arm's length to protect your hearing.
To carry out a test, hold the Test button down for just 3-
5 seconds.
Holding the Test button down for 15 seconds will reset the smoke
detector to the factory default settings. This will cause it to lose its
connection with Smartvest and other smoke alarm devices.
Weak batteries
Displays and functions
16