Blade Refueling; Tightness Adjustment Of The Blade - Altuna AB32 Manual De Uso

ALTUNA AB32

BLADE REFUELING

Please cut off the power source of the shears before operation.
Note: Refuel lubricating oil before using the blade or after it is used for
more than 4h. For correct refueling mentioned above, the blade needs to be
opened.
REFUELING STEPS
Fueling hole in the pin hole of the blade on the back of the shears. Squeeze the lubricating oil
from the oil bottle into the fueling hole and cut nothing for several times to make the lubricating
oil evenly distributed.

TIGHTNESS ADJUSTMENT OF THE BLADE

Be sure to cut off the power source between the shears and the
battery pack before operation.
Check the tightness of the blade before use. A blade with proper tightness will not swing
left and right. Proper tightness of the blade will make it labor-saving when pruning using the
shears.
Caution: When the blade is closed, the blade should not have a lateral swing. Lateral swing is
an abnormal state, given it will create a gap between the two blades and causes the teeth of
the gears to not properly mesh, thus damaging the mechanical structure.
|
30
EN
Refueling place of
lubricating oil
|