Party Light & Sound PARTY-SPOT7 Manual De Instrucciones página 3

Fixture Linking
You will need a serial data link to run light shows of one or more fixtures using a DMX-512 controller or to run
synchronized shows on two or more fixtures set to a master/slave operating mode. The combined number of
channels required by all fixtures on a serial data link determines the number of fixtures that the data link can
support.
Data Cabling
To link fixtures together you must use data cables. If you choose to create your own cable, please use data-grade
cables that can carry a high quality signal and are less prone to electromagnetic interference.
CABLE CONNECTORS
Cabling must have a male XLR connector on one end and a female XLR connector on the other end.
DMX connector configuration
Termination reduces signal errors. To avoid signal transmission problems and interference, it is always advisable to
connect a DMX signal terminator.
CAUTION
Do not allow contact between the common and the fixture's chassis ground. Grounding the common can cause a
ground loop, and your fixture may perform erratically. Test cables with an ohm meter to check correct polarity and
to make sure the pins are not grounded or shorted to the shield or each other.
Mounting
The LED moving head provides a unique mounting bracket assembly
that integrates the bottom of the base, the included 'omega bracket'
and the safety cable rigging point in one unit (see the illustration on the
right).When mounting this fixture on a truss, be sure to use an
appropriate clamp with the included omega bracket using a M10 screw
fitted through the center hole of the 'omega bracket'. As an added
safety measure, be sure to attach at least one properly rated safety
cable to the fixture using one of the safety cable rigging points
integrated in the base assembly.
When selecting installation location, take into consideration lamp
replacement access and routine maintenance.
Safety cables must always be used. Never mount in places where the
fixture will be exposed to rain, high humidity, extreme temperature
changes or restricted ventilation.
©Copyright LOTRONIC 2017
COMMON
DMX +
INPUT
DMX-
PARTY-SPOT7
Resistance 120 ohm
1/ 4w between pin 2
(DMX-) and pin 3
(DMX+) of the last
fixture.
Page 3