Grease Filter - Gorenje S3/WHI641ST Manual De Instrucciones

saturated).
Activation of the charcoal filter saturation indicator
The saturation indicator of the charcoal filter is normally disabled. To activate it, proceed in the following manner:
With the display on (ON) and the suction off (OFF), press simultaneously the buttons T8 and T9 for more than 3
seconds; the button T9 lights on with steady light for approx. 5 seconds, to indicate the activation.
To disable it, repeat the operation; the button T9 will flash for approx. 5 seconds to indicate the disabling.
Setting of Automatic Operation parameters
For correct use of the automatic operation, perform "Hood Calibration".
Hood Calibration
With the display on (ON) and the suction off (OFF), press button T3 for 3 seconds.
The suction speed (power) 1 starts functioning and button T3 flashes to indicate that hood calibration is initiated and it will
last for approx. 5 minutes.
Note: to interrupt the calibration, press T3 for 5 seconds; the calibration will be invalidated and should therefore be repeated.
MAINTENANCE
ATTENTION! Before performing any maintenance operation, isolate the hood from the electrical supply by switch-
ing off at the connector and removing the connector fuse.
Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket.
Cleaning
The cooker hood should be cleaned regularly (at least with the same frequency with which you carry out maintenance of
the fat filters) internally and externally. Clean using the cloth dampened with neutral liquid detergent. Do not use abrasive
products. DO NOT USE ALCOHOL!
WARNING: Failure to carry out the basic cleaning recommendations of the cooker hood and replacement of the filters may
cause fire risks. Therefore, we recommend observing these instructions. The manufacturer declines all responsibility for
any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety
recommendations.

Grease filter

Traps cooking grease particles. The grease filter must be cleaned once a month using non aggressive detergents, either
by hand or in the dishwasher, which must be set to a low temperature and a short cycle. When washed in a dishwasher, the
grease filter may discolour slightly, but this does not affect its filtering capacity. To remove the grease filter, pull the spring
release handle.
Charcoal filter
(filter version only)
It absorbs unpleasant odours caused by cooking. The saturation of the charcoal filter occurs after more or less prolonged
use, depending on the type of cooking and the regularity of cleaning of the grease filter. In any case it is necessary to replace
the cartridge at least every four mounths. The charcoal filter may NOT be washed or regenerated.
Replacing lamps
The hood is equipped with a lighting system based on LED technology. The LEDs guarantee an optimum lighting, a duration
up to 10 times as long as the traditional lamps and allow to save 90% electrical energy.
For replacement, contact the technical service.
34