Operating Mode - Makita XCV19 Manual De Instrucciones

Press the check button on the battery cartridge to indi-
cate the remaining battery capacity. The indicator lamps
light up for a few seconds.
Indicator lamps
Lighted Off
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
NOTE: The first (far left) indicator lamp will blink when
the battery protection system works.
Indication panel
► 1. Operating mode 2. Excess level of dust
3. Brushroll error 4. Remaining battery capacity
5. Battery check / LED lamp button

Operating mode

To change the operating mode, refer to the section for
switch action.
Excess level of dust
If this indicator lights up, replace the filter bag. (Refer
the section of removing the filter bag.)
NOTE: This indicator does not work when the appli-
ance operates in "lower noise level (1)" mode.
NOTE: This indicator may not work depending on the
usage environment.
Remaining
capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have
malfunctioned.
1
2
3
4
5
Brushroll error
Blinking
On
WARNING:
ance when this lamp lights up during operation.
Otherwise the motor malfunction may occur and
cause fire.
Remaining battery capacity
During operation, press the battery check / LED lamp
button to indicate the remaining battery capacities. The
battery indicators correspond to each battery.
Battery indicator status
On
Battery check / LED lamp button
During operation, the following operations can be
performed.
• Simply press the button to check the remaining
battery capacity.
• Press and hold the button to turn on / off the LED
lamp.
10 ENGLISH
The brushroll is under high
load for some reasons.
The brushroll is stopped by
abnormal reason.
Immediately switch off the appli-
Off
Blinking
Remaining
battery
capacity
50% to 100%
20% to 50%
0% to 20%
Charge the
battery