To Select A Training Scenario; To Run A Training Scenario - Laerdal HeartStart FRx Trainer Instrucciones De Utilizacion

FRx Trainer 10-04-07 15:12 Page 11

To select a training scenario

Make sure the pads connector is plugged in and the FRx Trainer is turned off.
(Press and hold the On/Off button if necessary to turn off the Trainer.)
1. Press the flashing i-button once.The FRx Trainer will tell you how to select
a scenario.
2. Press the i-button again to have the FRx Trainer identify the current training
scenario. If you want to use this scenario, briefly press the On/Off button to run
the scenario immediately.
3. To select a different scenario, press the flashing blue i-button to scroll through
each of the eight scenarios in sequence.When you reach the scenario number
you want, briefly press the On/Off button to run the scenario immediately.
Or, to simply select the scenario without running it, press and hold the On/Off
button until the Trainer turns off, or wait for 10 seconds and it will automatically
turn off.
The FRx Trainer will run the selected scenario every time until the batteries are
replaced or until a different scenario is selected.The Trainer defaults to Scenario 1
each time the batteries are installed.
To run the selected training scenario, treat the FRx Trainer exactly as you would
the FRx Defibrillator.
1. Press the green On/Off button to turn on the FRx Trainer.
2. To practice defibrillation of an infant or child under 8 years or 55 pounds
(25 kg), insert the Infant/Child Key in the Trainer's Infant/Child Key slot.
NOTE: Inserting or removing the Infant/Child Key during a scenario will restart
the scenario.
11
FRx TRAINER 861307