3- Drainage; 4- Final Installation - Saunier Duval 3-025 AW Manual De Instalación

4- INSTALLATION OF THE UNIT

4.3.3- Drainage

Run the drain hose sloping downward. Do
not install the drain hose as illustrated
below.
1 Curved upward
and downward.
Hose end
2
submerged in
water.
3 Corrugated.
4 Distance to
ground too
short.
5 If the end of the
hose is close
to the water,
this can be at
the origin of
bad smells that
can penetrate
into the room's
atmosphere.
When connecting an extension drain
hose, insulate the connecting part of the
extension drain hose with a shield pipe:
Drain hose

4.3.4- Final installation

1 Pass the piping through the hole in the
wall.
2 Put the claw at the back of the unit on
the hook of the installation board. Move
the unit from side to side to see that it is
securely hooked.
3 Piping can easily be made by lifting he unit
with a cushioning material between the
unit and the wall. Get it out after finishing
the piping.
4 Push the lower part of the unit up to the
wall. Then, move the unit from side to
side, up and down, to check if is securely
hooked.
Less than
Menos de
5 cm
5 cm
8
Shield pipe
Wall
Extension
drain hose