Cleaning Instructions - Bosch Relaxx’x BGS 5 Serie Instrucciones De Uso

Tapping out the plate filter
24
Figure
If the plate filter is particularly dirty, the dirt can also
be tapped out.
● Tap out the filter over a dustbin.
The dirt will fall down out of the filter.
Cleaning the fluff filter
The fluff filter should be cleaned at regular intervals in
order to ensure optimum operation of the vacuum cleaner.
25
Figure
● Open the appliance lid and remove the dust contai-
ner from the appliance.
a)Take the filter unit out of the dust container.
b)It is usually sufficient to lightly shake or tap out the
whole filter unit when the dust container is emptied
in order to dislodge any particles of dirt.
If this is not sufficient, you can use a dry cloth to
remove dirt particles from the fluff filter.
Cleaning the motor protection filter
The motor protection filter should be cleaned regularly
by knocking out the dirt and rinsing.
26
Figure
a)Open the appliance lid and remove the motor protec-
tion filter.
b)Clean the motor protection filter by tapping out the
dirt. If it is very dirty, the motor protection filter
should be rinsed. Then allow the filter to dry comple-
tely.
c) After cleaning the motor protection filter, reinsert it
into the appliance and close the appliance lid.
Cleaning the exhaust filter
The exhaust filter is designed so that it does not need
to be replaced, provided the appliance is used as inten-
ded in the household.
To ensure that the vacuum cleaner is working at its
optimum power level, the exhaust filter should be rin-
sed out after 1 year. The filtering action of the filter
remains intact, even if the filter surface becomes dis-
coloured.
17
Figure
Cleaning the HEPA filter
27*
Figure
● Open the appliance lid and remove the dust contai-
17
ner.
Figure
a)Use the locking tab to open the side flap.
b)Pull the two locking tabs to unlock the filter unit with
HEPA filter and remove it from the appliance.
c) Tap out the filter unit and rinse it under running
water.
d)Only reinsert the filter unit into the appliance after it
has dried completely and ensure that it audibly clicks
into place.
e)Close the side flap until you hear the locking tab
click into place again.
f) Insert the dust container into the appliance and
close the appliance lid.
Cleaning the micro filter
28*
Figure
● Open the appliance lid and remove the dust contai-
ner. 17
Figure
a)Use the locking tab to open the side flap.
b)Pull the two locking tabs to unlock the filter unit with
foam filter and micro filter and remove it from the
appliance.
c) Remove the foam filter and micro filter from the filter
frame.
d)Foam filter and micro filter and rinse it under running
water.
e)Do not re-insert the foam filter and the micro filter
into the filter frame until it has dried completely
f) Insert the filter unit in the appliance and ensure that
the locking tabs audibly click into place.
g)Close the side flap until you hear the locking tab
click into place.
h)Insert the dust container into the appliance and
close the appliance lid.

Cleaning instructions

Always switch off the vacuum cleaner and disconnect
the power cord from the mains before cleaning the
vacuum cleaner. The vacuum cleaner and plastic acces-
sories can be cleaned with an ordinary plastic cleaner.
!
Caution: do not use a scourer, glass-cleaning agent
or multipurpose cleaning product. Never immerse
the vacuum cleaner in water.
Subject to technical modifications.
*
dependent on model
41